Buying Guide

Best Screen for XGIMI AURA 3 Max & Pro (4K 120Hz UST)

Published November 05, 2026 · TrueThrow

Shop the screens in this guide

View all UST Screens →

XGIMI's AURA 3 series — the AURA 3 Max and AURA 3 Pro — launched as the world's first 4K/120Hz ultra short throw projectors, bringing console-grade gaming refresh rates to a laser TV for the first time. Both are triple-laser 4K UST projectors that sit on a low cabinet just inches from the wall, with the AURA 3 Max reaching up to 5,700 ISO lumens and the AURA 3 Pro up to 4,100 ISO lumens. That brightness gap changes which TrueThrow screen makes the most sense for each model.

This guide covers the right UST screen for both AURA 3 models, how far to place them from your screen, and which TrueThrow option fits the size you're planning.

XGIMI AURA 3 Throw Ratio and Screen Requirements

Both AURA 3 models share the same optical design: a 0.163:1 throw ratio, one of the shortest throw ratios available in a consumer UST projector. XGIMI rates the AURA 3 at roughly 8 inches (20 cm) from the wall for a 120" image — scaling proportionally, that's about 17 cm for a 100" screen and up to 34 cm for a 200" screen. Like every UST projector, the AURA 3 fires light upward at a steep angle, which means it requires a UST Fresnel or lenticular ALR screen — a standard matte white or grey screen will scatter that steep-angle light and produce a dim, washed-out image with poor contrast.

Why the Max vs. Pro Brightness Gap Changes the Screen Decision

XGIMI rates the AURA 3 Max at up to 5,700 ISO lumens (8,000:1 contrast) and the AURA 3 Pro at up to 4,100 ISO lumens (7,000:1 contrast) — both are bright by UST standards, but the gap matters for screen selection:

  • AURA 3 Max in a bright room: The extra lumens mean you can push a higher ambient-light-rejection screen without losing perceived brightness — this is where a carbon-black lenticular surface pays off, delivering deeper blacks while the Max's output compensates for the screen's lower reflectivity.
  • AURA 3 Pro in a typical living room: At 4,100 lumens, a standard Fresnel ALR or value-tier lenticular screen maximises visible brightness without over-rejecting ambient light you don't need to fight as hard.
  • Either model in a fully dark room: Both have more than enough output that screen choice becomes about contrast and viewing angle rather than raw brightness.

Best TrueThrow Screens for XGIMI AURA 3

1. TrueThrow Premium Carbon-Black Lenticular UST Screen (HBSP) — Best for AURA 3 Max in Bright Rooms

The Premium Carbon-Black's higher-grade optical structure and deeper ambient light rejection pairs naturally with the Max's 5,700-lumen output — you get the Max's brightness headroom back as usable contrast, even with some room lighting on. Available 80"–120".

2. TrueThrow Carbon-Black Lenticular UST Screen (CBSP) — Best Value for AURA 3 Pro

For the AURA 3 Pro's 4,100 lumens, the standard Carbon-Black Lenticular screen delivers strong ambient light rejection without needing the Max's extra brightness to drive it. Available in 120" and 130".

3. TrueThrow Fresnel ALR UST Screen — Best All-Round, Either Model

The Fresnel ALR's 2.0–2.5 gain makes it the most forgiving, highest-brightness option for either AURA 3 model, especially if you're running the Pro in a room with more ambient light than ideal. Available 84"–120".

4. TrueThrow Motorized Floor-Rising UST Screen — Best for Clean Living Rooms, Largest Sizes

If you want the AURA 3 in a true "disappearing TV" living room setup, the motorized floor-rising screen retracts fully into its housing when not in use. It's also TrueThrow's largest UST option, reaching 150" — the practical ceiling for the AURA 3 Max's full brightness in a large room.

XGIMI AURA 3 vs Other UST Brands: Does Screen Choice Change?

No — TrueThrow UST screens are compatible across all major UST brands, including AWOL Vision, Hisense, Samsung, and LG. The spec that matters is throw ratio (TrueThrow's UST lineup covers 0.19:1–0.30:1), not brand. At 0.163:1, the AURA 3's throw ratio is shorter than TrueThrow's rated range — in practice this means placing the projector slightly further from the wall than its minimum spec to land within the screen's designed optical zone; XGIMI's zoom and lens-shift controls (available on both AURA 3 models) make this straightforward during setup.

Size Guide for XGIMI AURA 3

At the AURA 3's 0.163:1 throw ratio, approximate placement distances (projector cabinet to wall):

  • 100" screen → ~17 cm (6.7")
  • 120" screen → ~20 cm (8")
  • 130" screen → ~22 cm (8.7")
  • 150" screen → ~25 cm (10")

Note: XGIMI's AURA 3 supports screen sizes up to 200", but TrueThrow's current UST lineup tops out at 150" (Motorized Floor-Rising and PET Crystal Lenticular) — which covers the realistic range for the large majority of living rooms. If you're planning a 150"+ install and want to confirm sizing, contact TrueThrow directly.

Not sure this is the exact match for your room? Answer 3 quick questions in our free Screen Finder quiz and we'll confirm the gain and size for your XGIMI AURA 3.

🛒 Shop TrueThrow UST Screens for XGIMI AURA 3

Direct pricing — no retail markup. Ships free on orders of $499+.

Frequently Asked Questions

Can I use a regular projector screen with the XGIMI AURA 3?

No. The AURA 3 is an ultra short throw projector that fires light at a steep upward angle from just inches away. A regular matte white or grey screen scatters that light unevenly, producing a dim, low-contrast image. You need a UST Fresnel or lenticular ALR screen designed for short throw ratios.

What's the difference between the AURA 3 Max and AURA 3 Pro for screen selection?

Both use the same 0.163:1 throw ratio and need the same type of UST screen. The Max's higher brightness (5,700 vs. 4,100 ISO lumens) means it can drive a higher ambient-light-rejection screen like the Premium Carbon-Black without losing visible brightness, while the Pro pairs well with a standard Fresnel ALR or Carbon-Black screen.

Does TrueThrow have a 200" screen for the AURA 3 Max?

Not currently — TrueThrow's largest UST options (Motorized Floor-Rising and PET Crystal Lenticular) top out at 150", which suits the vast majority of living rooms. Contact TrueThrow directly if you're planning a larger custom install.

What size AURA 3 screen should I buy?

For a typical living room (12–15 ft wide), 100"–120" is the sweet spot. The AURA 3 Max's brightness supports sizes up to 150" without losing image quality, provided your room has the width — a 150" 16:9 screen is roughly 131" (nearly 11 feet) wide.

TrueThrow is an independent projector screen brand and is not affiliated with, sponsored by, or endorsed by XGIMI. Brand and model names are used solely to identify compatible screen sizing and are trademarks of their respective owners.

Ready to upgrade your screen?

Factory-direct pricing. Free standard shipping on orders of $499+ across Canada, with duties and import fees included.